Plot four points A(-4,1), B(-1,-2), C(4,1) and D(3,4) on a rectangular.
coordinate plane. Find the coordinates of the point of intersection of AC
and BD. *
O (0.1)
O (1,1)
0 (0,2)
O (1,0)

​

Tibet is one of the least densely populated regions in China.

Explanation:

China is one of the biggest countries in the world, and it is also the most populated country in the world. Despite having more than 1.3 billion people, China's population tends to be concentrated in certain parts of the country, while others have very low population density. In general, the eastern parts of the country tend to be the most populated, while the northern and western tend to be the least populated.

Some of the least populated regions in China are:

Tibet is one of the four regions in China that has population density of below 50 people per square km. The basic reason for this is the geography of this region. It is a very high region, connected with the Himalayas, with very little arable land, and very harsh climate. Naturally, the people have avoided this region, as apart from having harsh conditions, it is also not a region that can support large population.

Learn more about Xinjiang https://brainly.com/question/7178318

#learnwithBrainly

temperature and precipitation

Explanation:

The temperature and precipitation a place receives determines the climate of a particular region.

Climate is the average weather condition over a place for an extended period of time.

learn more:

Weather https://brainly.com/question/1851697

#learnwithBrainly

Answer:

D. temperature and precipitation

Explanation:

Hope this helps!

The question asks to match climate zones to their correct locations on a map. If unsure or wrong, answers can be cleared by dragging to a trashcan icon and clicking it.

The core task of this question is a geography-based interactive activity where you are asked to match different climate zones to their corresponding locations on a map. These climate zones are likely labeled with 'X' marks on the map. To successfully complete this task, you need to click on a climate zone name and then click on the corresponding 'X' that matches the location of that climate zone on the map. If you are unsure or need to change your answer, you can drag the item to a trashcan icon, and click on the trashcan to clear all your answers.

https://brainly.com/question/32220876

#SPJ3

The concepts of Russification and satellite countries relate to Soviet expansion because the authority seeks to expands Soviet union and keeping its united while doing so.

Russification is a policy that was adopted to fish-out the people who wanted to reform Russia, hence, its aims to unite the Russian people around one leader who is Tsar.

Also, the Soviet expansion was the expansion of Soviet union towards the Eastern Europe.

In conclusion, the concepts of Russification and satellite countries relate to Soviet expansion because the authority seeks to expands Soviet union and keeping its united while doing so.

Read more about Russification

brainly.com/question/8820260

Answer:

What is the cross word?

Answer: Its "D"

Explanation:

the answer is D due to lakes rivers and mountains being natural barriers. Which in turn creates a boundary between to states or countries.  

The two ways to reduce wind erosion are Strip Farming and Shelterbelts.

Explanation:

Wind Erosion is the removal of soil due to winds causing loss of the nutrient-rich top-soil, which is highly favorable in the growth of crops.

There are two ways to reduce wind erosion.

1. Strip Farming - In this method, crops are grown in alternate strips. Grasses are grown in between the strips and helps reduce the loss of soil due to winds. This method is the best way of wind breaking.

2. Shelterbelts - Trees are grown as shelterbelts reducing the wind speed to prevent soil erosion. The heights of the trees act as a barrier that stops heavy winds from damaging the crops.

A lifecycle of star can be determined by the mass of the star.

Explanation:

Stars are formed by the clouds of gases as well as the dust which is known as nebulae. Stars also come across a cycle that is a star is formed from gases and dust , then its grow more , various changes take place while growing after that the life span ends. Millions of year take for the formation of a star, while its growing process it shines brightly for several years. When the fuel present in the stars are exhausted , the star collapse as a result explosion of the outer layer takes place which is referred to as a supernova.

Answer:

D. Maori and English versions of the treaty didn't match

Explanation:

Answer:

D.

Maori and English versions of the treaty didn't match

Explanation:

According to European commission immigration is defined as an  action by which a person from a non-European country starts residing  in the territory of an EU country for a period that has to be at least 12 months.

Explanation:

Immigration policies are a concern in Western Europe because

A green card is proof of permanent residence for immigrants in the United States. It allows an individual who is not a citizen of the United States to live and work permanently in the country.

A green card is proof of permanent residence for immigrants in the United States. It allows an individual who is not a citizen of the United States to live and work permanently in the country. The green card, also known as a Permanent Resident Card, is issued by the U.S. government to foreign nationals who meet specific criteria and have been granted lawful permanent resident status.

Continental volcanoes are linked to oceanic-continental convergent boundaries through subduction, resulting in a trench and volcanic arc.

Continental volcanoes are associated with oceanic-continental convergent boundaries due to the subduction of an oceanic plate beneath a continental plate. This subduction leads to the formation of a trench and a volcanic arc along the boundary.

Answer:

Topographic maps show elevation of landforms above sea level

Explanation:

Topographic maps represent physical land features and elevations through contour lines, serving as detailed tools for navigation and understanding terrain. Thematic maps focus on specific themes or data like demographics or land use, showing spatial patterns related to the chosen subject. Each type of map serves different purposes, with topography maps used for terrain navigation and thematic maps for illustrating specific data patterns.

Difference Between Topographic Maps and Thematic Maps

Topographic maps and thematic maps are crucial tools for visualizing different aspects of the Earth's surface and human activity. Here, we'll outline four key differences between them:

Significance in Use

Topographic maps are often used where detailed knowledge of terrain is vital, whereas thematic maps are invaluable in planning, analysis, and education where understanding spatial patterns of various themes is crucial.

Answer:

https://geohistory.today/russian-far-east/

Explanation: Check out this website. It have different resources in Eastern Russia

In Siberia, to the east of 90° E in Russia, the most common resources are oil and natural gas, along with mineral resources such as nickel, gold, and platinum, contributing greatly to the country's economy.

The most common resource found in Russia to the east of 90° E, particularly in the Siberian region, is a vast abundance of oil and natural gas. This area is known to be a treasure trove of energy sites and mineral resources, including nickel, gold, and platinum. Although sparsely inhabited, Siberia's wealth in natural resources plays a significant role in Russia's economic future, with cities like Magnitogorsk and Norilsk established specifically for the extraction and processing of these valuable resources.

Explanation:

Developing nations have a higher level of industrial fog than developed nations. This is because the nations are developing rapidly and at higher rates than the developed nation, Therefore they consume a lot of energy to spur this economic development. However, due to their need for cheap energy to power this rapid industrial development, they opt for cheap nonrenewable sources of energy like coal which are the highest populations. This is why cities in countries like India and China have the highest levels of smog.

Most developed nations, on the other hand, are shifting towards renewable energy sources –even though they are currently more expensive than non-renewable energy- because they have the resources.

Learn More:

For more on renewable and non-renewable sources of energy check out;

https://brainly.com/question/4432642

https://brainly.com/question/1757270

https://brainly.com/question/10083394

https://brainly.com/question/9870566

#LearnWithBrainly

Levels of industrial smog are generally higher in developing nations compared to developed nations due to differences in industrial regulations and pollution control measures.

In developing nations, rapid industrialization, lax environmental regulations, and the use of outdated technologies contribute to higher levels of industrial smog. These countries often prioritize economic growth over environmental protection, leading to significant air pollution problems.

In contrast, developed nations have implemented stricter environmental regulations and advanced technologies to reduce industrial emissions. These measures, combined with a greater focus on sustainable practices, have significantly lowered industrial smog levels in these countries.

They enforced the principles of intervention by the United States in the Caribbean region.

Explanation:

The United States would not be involved in European Wars. America's foreign policy related to isolationism was continued by them. Imperialism was practiced by the United States . Principles of intervention was enforced in the Caribbean region by the United States. Thus the enforcement of the principle of intervention by the United States in the Caribbean region was considered as the accurate conclusion about the relationship between Roosevelt's Big Stick Policy and the Platt Amendment.

Answer:

light years

Explanation:

Answer:

is expanding more and more

Answer:

I would not consider the fact of bearing five sons at once and loosing all of them again.

Explanation:

Answer:

B. 100

Explanation:

3/4 can be turn to 75/100 but 59/100, the denominator, 100, cannot.

Answer:

The answer is plant growth, animal actions, and pressure release.

Explanation:

I just took a quiz with this question and I got it correct.

Answer:  The answer is A: get permission from the U.S. government to enter.

Explanation: I don't know why, I think it has something too do with the government being paranoid of terrorist attacks.

Answer:

A fault is formed in the Earth's crust as a brittle response to stress. Generally, the movement of the tectonic plates provides the stress, and rocks at the surface break in response to this. Faults have no particular length scale. If you whack a hand-sample-sized piece of rock with a hammer, the cracks and breakages you make are faults. At the other end of the spectrum, some plate-boundary faults are thousands of kilometers in length.

Explanation:

Based on the information provided in the image, the most likely location where water emerges from the surface as a spring is C.

Here's why:

Springs typically occur where the water table meets the ground surface. In the image, the water table is represented by the blue line. We can see that the water table intersects the ground surface at location C.

Springs are also often found at the base of hills or slopes. This is because the water table is usually higher in these areas. In the image, location C is at the base of the slope.

Locations A, B, and D are all uphill from location C. This means that the water table is lower in these locations, and it is less likely that a spring would form there.

Therefore, based on the principles of hydrology and the information provided in the image, location C is the most likely spot for a spring to emerge.

According to the principles of hydrology and the information provided in the image, location C is the most likely spot for a spring to emerge.

Springs typically occur where the water table meets the ground surface.

In the image, the water table is represented by the blue line.

We can see that the water table intersects the ground surface at location C.

Springs are also often found at the base of hills or slopes.

This is because the water table is usually higher in these areas.

In the image, location C is at the base of the slope.

Locations A, B, and D are all uphill from location C.

This means that the water table is lower in these locations, and it is less likely that a spring would form there.

Therefore, According to the principles of hydrology and the information provided in the image, location C is the most likely spot for a spring to emerge.

1. Dense forest with large trees on steep hills: There were steep hills covered by forests made by large trees. The roots of these trees ceased soil erosion from happening.

2. Hand logging near lakes: People began to cut trees for wood but the pace was not as fact.

3. Mechanized logging throughout hills: Techniques of mechanized logging were developed and which helped in clearing the trees from over the hills within months.

4. Erosion fills lakes with silt: Clearing of forests from over the hills caused soil erosion and the silt from the hills flowed down with rainwater runoff.

Answer:

60/120 = 50%

Final answer:

The efficiency of a light bulb is the ratio of luminous flux in lumens to electric power consumed in watts, which is known as luminous efficacy. It's essential for comparing light bulbs' energy efficiency, but factors like lifespan and cost are also important.

Explanation:

The efficiency of a light bulb can be written as the ratio of luminous flux to electric power consumed. Luminous flux is the measure of the perceived power of light, and it is quantified in lumens (lm), while the electric power consumed by the bulb is measured in watts (W). To determine the efficiency, we take the number of lumens a bulb produces and divide it by the number of watts it uses. This efficiency, known as luminous efficacy, is critical for understanding the energy efficiency of different lighting technologies, such as incandescent bulbs, compact fluorescent lamps (CFL), and LED bulbs.

For instance, a 60-W incandescent bulb may produce the same lumens as a 15-W LED, but the LED is more efficient because it uses less power for the same light output. When comparing bulbs, especially for energy saving and cost effectiveness, it's essential to look at lumens rather than watts. Notably, because of other factors, the efficiency should not be the sole consideration; the bulb's lifespan and cost should also be taken into account.

A patient who has tertiary insurance would have three types of coverage.

Explanation:

When a patients has two insurance policies for claiming the first one will be considered as primary and the second on will be secondary. When there is an additional policy that is to be covered then it is called as tertiary insurance policy. In this type of policy there will be three types of coverage.

The primary insurance policy is used for covering the costs that are mentioned in the policy limits. The costs that are not covered by primary policy is covered by the secondary policy. The tertiary insurance is the one that covers all additional costs and hence it is considered as the third level insurance.

More water is siphoned off the Jordan River for agriculture.

Explanation:

The Dead Sea is actually a lake that has a saline water. In fact, it is the water of body that has the highest salinity in the world. It is located in a depression, the deepest in the world, and also in an arid area. This lake is getting water from the Jordan River, and it doesn't have an outlet, but despite that, the lake is actually gradually decreasing lately.

There are two main reasons as two why the decrease of the water levels occurs. The main reason is that more and more water from the Jordan River is used by the population in the region, be it for drinking or irrigation, which in turn means that the amount of water that enters the Dead Sea is decreased. That combined with the second reason, which is the arid climate, contributes to higher evaporation of the water than water that enters the lake, thus the water levels gradually go down.

Learn more about vaporization and evaporation https://brainly.com/question/24258

#learnwithBrainly

More water is being siphoned off the Jordan River for agriculture.

Explanation:

The level of the Dead Sea's water keep decreasing round the year because more water is being siphoned off the Jordan River for agricultural needs.

The dead sea is the saltiest water on earth making its very dense.

It is an inland sea with no connection to an ocean. In fact, it is better described as a lake.

The feeder river the provides water into the Dead sea is River  Jordan.

Most people living around this river use it for irrigation of farms. This eventually reduces discharge into the Dead sea.

learn more;

Agriculture https://brainly.com/question/751210

#learnwithBrainly

Answer:

Upward Expansión is the correcto answer